Painted 3D Prints
PA12 Nylon
Textured and painted to simulate the look and feel of a finished injected molded part.
PA12 3D Printing
Textured and painted to simulate the look and feel of a finished injected molded part. We offer this service in three finishes: VDI 40, Hammered Spatter, and Primer.
General Capabilities
Tolerances
+/-0.2mm base
Additional +/-0.5mm per every 100mm
Global Deviation:
Feature Location
Pockets, holes, slots and other features can be on any side of the part. Holes are necessary to remove the support material of a hollow model. All features should be line of sight for best results.
Part Size
X and Y Axis
Minimum:
Maximum:
10mm (0.40in)
250mm (9.80in)
Z Axis
Minimum:
Maximum:
6mm (0.25in)
250mm (9.80in)
Features
Internal Corner Radius
Minimum:
0.5mm (0.02in)
Walls
Minimum Thickness:
Nominal Thickness:
Height To Thickness:
0.8mm (0.031in)
1.5mm (0.06in)
8:1 or 8x Height Recommended
Embossed Detail
Minimum Height:
Minimum Width:
0.8mm (0.031in)
0.8mm (0.031in)
Overhangs and Undercut
Line of sight is needed for all deep pockets and sharp corners. Failure to do so can result in un-fused powder trapped in the part.
Pockets
Minimum Width:
Depth To Thickness:
2mm (0.08in)
3:1 or 3x Depth
Materials
Plastics
-
PA12